Calibration method for loader electronic scale

Calibration method for loader electronic scale

Guihu tells you a simple method. 1. Select the calibration mode:
Through the weighing parameters, enter the area ratio and time compensation interface, the correction type is selected as two points; pay attention to the need to re-correct after selection.

Second, the loader electronic scale correction angular displacement:
Through the system parameters, enter the installation location interface, lift the boom to the horizontal down position, and then perform an angle-key correction.
1. The hydraulic system is fully preheated until the pressure value does not change.
2. Empty the bucket, step on the engine throttle, and then lift it to keep the speed of the lift steady. After the lift is finished, press to proceed to the next step.
3. Fill the bucket;
4. Step on the throttle and then lift it. Make sure to keep the speed and process of the lift process steady. Press the lift and proceed to the next step.
5. Fill in the weight.
6. The calibration was successful.

Third, the loader electronic scale weighing correction:
After the preparation is completed, enter the main interface - weighing correction interface.
How to test whether the calibration is successful?
Raise the 5T weight block. If the weight indicates that the up and down error does not exceed 30Kg, the test passes, otherwise it is recalibrated.

Multi Span Plastic Film Greenhouse

Arch greenhouse is a kind of economical greenhouse, which is welcomed by the users with graceful curve form and low cost. It has beautiful appearance, fluent visual, reasonable structure and good performance for keep temperature. It is economical greenhouse because of its relatively low manufacturing cost. It can be applied in most areas of China. Double membrane greenhouse is used more in north of China, while single film greenhouse is used more in southern region. It can get maximum sunlight when visible light is within the scope of 0.4 to 0.7 microns and form a thick envelope, which can effectively prevent heat loss and prevent the invasion of cold air. Adopting a double membrane can greatly improve heat preservation performance of the greenhouse and save operating cost. The top cover material is polyethylene lifelong anti-fog and anti-dipping film po-covering. The outer of it has the function of UV protection and the inner has the function of preventing from the sets of dew. According to the needs of customers, the sides of the greenhouse can be covered with polyethylene lifelong anti-fog and anti-dripping po-covering or polycarbonate hollow plate.

Multi Span Plastic Film Greenhouse,Pc Board Greenhouse,Pc Sheet Covering Greenhouse,Greenhouse Pc Board

JIANGSU SKYPLAN GREENHOUSE TECHNOLOGY CO.,LTD , https://www.greenhousehydroponic.com